Adjusting the image

Refer to these notes when adjusting the projected image as described in the included SLR60wi textless installation guide (smarttech.com/kb/170259).

• While adjusting the projected image size, shape and location, disconnect your computer from the projector, and then use the projector’s default background, or the test image from the test menu, so that you can see the full projected image clearly. Don’t use other images, which might be cropped or scaled by the projector and could result in a misleading projected image size, shape and location.

• Use the projector’s ball joint lever, keystone screws and boom length mechanical adjustments to make all physical image adjustments. Don’t use the projector’s on-screen menu options during the projector alignment process. See smarttech.com/kb/170259 for more information.

• Be aware that as you tilt the projector up or lower its mounting boom to raise the image, the entire projected image increases or decreases in size, especially at the bottom of the projected image.

• Note 

  The center of the image is offset 1.75" to the left from the center of the mounting bracket with a tolerance of ± 2". See the LightRaise 60wi interactive projector installation template (smarttech.com/kb/170271) for more information.

• When you move the projector forward or backward on the boom to make the image larger or smaller, you might need to tilt or turn the projector slightly to keep the image square. Loosen the ball joint lever slightly to aid in this adjustment.

• To fine-tune the image, you might need to repeat all steps described in the installation document in smaller increments.