Orientating your interactive product

Although your interactive product is orientated by default, you can orientate it again to ensure precision.

If your computer is connected to more than one interactive product, you need to provide further information so that your computer knows which interactive product to orientate.

To orientate a single interactive product

1. Press the SMART Board icon in the notification area and then select Orientate.

   Targets appear on the screen.

   Notes 

   • On some interactive products, you can press the Orientate button or the Pen Tray and Keyboard buttons simultaneously to start the orientation procedure.

   • If your computer isn’t currently connected to an interactive product, the SMART Board icon includes an X in its lower right-hand corner.

2. Press the centre of each target in the order indicated. The computer registers the point on the interactive product where you remove your finger or pen from the surface.

   The orientation procedure involves touching 4, 9, 12 or 20 targets, depending on the orientation level that you select (see Changing the orientation level).

   Notes 

   • To effectively orientate the interactive product, press an area near each target and then slide your finger or pen to the centre of each target’s crosshairs before removing it. Keep your finger or pen at a right angle to the interactive product’s surface.

   • You can reorientate a target by pressing the two pen tray buttons simultaneously or the LEFT ARROW key on the keyboard.

   • If you want to close the orientation screen before finishing the orientation procedure, press ESC. Otherwise, the orientation screen closes after you press the last target.

To orientate multiple interactive products

1. Press the SMART Board icon in the notification area and then select SMART Settings.

   Note 

   If your computer isn’t currently connected to an interactive product, the SMART Board icon includes an X in its lower right-hand corner.

2. Select SMART Hardware Settings.

   The upper area of the control panel displays an image for each interactive product connected to the computer.

3. Select the interactive product that you want to orientate.

4. Press Orientate.

   Note 

   Sometimes, the orientation screen appears on your primary interactive product instead of the interactive product that you want to orientate. If this happens, press SPACEBAR until the orientation screen appears on the interactive product that you want to orientate.

5. Touch the centre of each target in the order indicated. The computer registers the point on the interactive product where you remove your finger or the pen tool from the surface.

   The orientation procedure involves pressing 4, 9, 12 or 20 targets, depending on the orientation level you select (see Changing the orientation level).