SMART Notebook 10 for Mac Operating Systems
If you set up a tool strip or custom icon strip, you can reposition these strips at any time.
Position the icon strips on either the left, right or bottom edge of the interactive product (in the black border). Wherever you position it, make sure that the edge of the strip is aligned with the frame of the interactive product. You must then recalibrate the position of the strip.
Open the SMART Notebook control panel.
Press SMART Hardware Settings.
The upper area of the control panel displays an image of the SMART product connected to the computer.
If your computer is connected to more than one SMART product, the upper area of the control panel displays an image of each SMART product. Press the image of the product with the settings you want to change.
Select Set Up Icon Strips in the list.
Select the icon strip you want to move.
Press Position Strip to display the calibration screen.
Follow the on-screen instructions to define the corners of the strip.
NOTE: If you press the interactive screen too far from the edge of the icon strip, an error message appears and you must try again.
Press OK to close the control panel.