Orienting your SMART Board interactive whiteboards after installation
If after you install SMART Meeting Pro software on a multiple display system your touch on one screen registers on another, you must orient your interactive product again.
Use the following procedure to orient your interactive product using SMART Settings.
Tip
You can also access the screen orientation procedure from the Pen Tray. See your interactive product’s user’s guide for more information.
To orient multiple interactive products
-
Press the SMART Meeting Pro icon 
in the notification area, and then select .
If your computer isn’t currently connected to an interactive product, the SMART Meeting Pro icon is gray and includes an X in its lower-right corner 
.
-
Select SMART Hardware Settings.
The upper area of the widow displays an image for each interactive product connected to the computer.
-
Select the interactive product you want to orient.
-
Press Orient.
Note
Sometimes, the orientation screen appears on your primary interactive product instead of the interactive product you want to orient. If this happens press SPACEBAR until the orientation screen appears on the interactive product you want to orient.
-
Touch the center of each target in the order indicated. The computer registers the point on the interactive product where you remove your finger or pen tool from the surface.
The orientation procedure involves pressing 4, 9, 12 or 20 targets, depending on the orientation level you select (see the SMART Meeting Pro software online Help for more information on changing the orientation level of your interactive product).