SMART education software for Windows operating systems
You are here: Using your interactive product > Configuring your interactive product > Enabling Non-Projected mode > Enabling Non-Projected mode

Enabling Non-Projected mode

If you don’t have a projector for your interactive product, you can use your interactive product in Non-Projected mode. You can write on the interactive product in Non-Projected mode with dry-erase markers and save your notes in a .notebook file.

Caution 

Check your interactive product’s installation guide for more information before writing on it with dry-erase markers. For example, don’t write on an interactive product if it has an OptiPro surface. OptiPro surfaces are optimized for use with Projected mode.

To enable Non-Projected mode

  1. Press the SMART Board icon in the notification area, and then select SMART Settings.

    Press the SMART Board icon in the system tray, and then select SMART Settings.

    Note 

    If your computer isn’t currently connected to an interactive product, the SMART Board icon includes an X in its lower-right corner .

  2. Press SMART Hardware Settings.

    If your computer is connected to more than one interactive product, the upper area of the SMART Settings window displays an image for each product. Press the image of the product you want to change settings for.

  3. Select Orientation/Alignment Settings in the drop-down list.

  4. Select Non-Projected (Whiteboard Mode).

    Note 

    To disable Non-Projected mode, select Projected (Mouse Mode).

  5. Press OK to close the SMART Settings window.

Also in this section

Using your interactive product in Non-Projected mode

© 2012 SMART Technologies ULC. All rights reserved. Last updated October 30, 2012.
Legal information