Orienting your SMART interactive product

To orient a single SMART interactive product

1. Press the SMART Board icon in the notification area, and then select Orient.

   Targets appear on the screen.

   Notes 

   • On some SMART interactive products, you can press the Orient button or the Pen Tray and Keyboard buttons simultaneously to start the orientation procedure.

   • If your computer isn’t currently connected to a SMART interactive product, the SMART Board icon includes an X in its lower-right corner.

2. Press the center of each target in the order indicated. The computer registers the point on the SMART interactive product where you remove your finger or pen from the surface.

   The orientation procedure involves touching 4, 9, 12 or 20 targets, depending on the orientation level you select (see Changing the orientation level).

   Notes 

   • To effectively orient the SMART interactive product, press an area near each target, and then slide your finger or pen to the center of each target’s crosshairs before removing it. Keep your finger or pen at a right angle to the SMART interactive product’s surface.

   • You can reorient a target by pressing the two pen tray buttons simultaneously or the LEFT ARROW key on the keyboard.

   • If you want to close the orientation screen before finishing the orientation procedure, press ESC. Otherwise, the orientation screen closes after you press the last target.

To orient multiple SMART interactive products

1. Press the SMART Board icon in the notification area, and then select SMART Settings.

   Note 

   If your computer isn’t currently connected to a SMART interactive product, the SMART Board icon includes an X in its lower-right corner.

2. Select SMART Hardware Settings.

   The upper area of the control panel displays an image for each SMART interactive product connected to the computer.

3. Select the SMART interactive product you want to orient.

4. Press Orient.

   Note 

   Sometimes, the orientation screen appears on your primary SMART interactive product instead of the SMART interactive product you want to orient. If this happens, press SPACEBAR until the orientation screen appears on the SMART interactive product you want to orient.

5. Touch the center of each target in the order indicated. The computer registers the point on the SMART interactive product where you remove your finger or the pen tool from the surface.

   The orientation procedure involves pressing 4, 9, 12 or 20 targets, depending on the orientation level you select (see Changing the orientation level).