You are here: Configuring SMART Meeting Pro software > Activating SMART Meeting Pro software after installation

Activating SMART Meeting Pro software after installation

There are two situations in which the software doesn’t activate completely:

Imaging a computer: For the software to activate properly, each computer you install it on must have a unique installation ID. If you use a computer image or clone a hard drive to set up multiple computers, they all have the same installation ID as the original computer, which can cause an activation error.
Protecting software for computer configurations: If you use system recovery or protection software, you should activate the software before you lock or freeze the computer for your users. However, if you can’t, you must activate the software afterward.

To activate SMART Meeting Pro software after installation

Run the following command:

"C:\Program Files\Common Files\SMART Technologies\SMART Product Update\activationwizard.exe" --puid meeting_pro --m=Value --v=3 --a Optional flags --pk Product key

Where

Value is 4 to run the activation wizard in unattended mode.

OR

Value is 6 to run the activation wizard in user interface mode.

Optional flags are optional flags you can include to configure the activation wizard.

Flag	Purpose
`--`monitor=Number	Specify the monitor to display the activation wizard.
`--`proxy=Host:Port	Specify the proxy host and port number to use for activation.
`--`proxyuser=User	Specify the proxy user name to use for activation.
`--`proxypassword=Password	Specify the proxy password to use for activation.
`--`locale=Code	Display the activation wizard user interface in a specific language, where Code is your language code (see Installation language files and codes).

Product key is the software product key.

Also in this section

Adding a unique e-mail address to each computer after installation

Orienting your SMART interactive product after installation

Configuring 4K UHD displays